Revell 23955 Instruções de Utilização descarregar pdf (Página 9)

English

16 17

4 CHARGING THE HELICOPTER

Attention: The battery must cool down for 10 to 15 minutes before

charging and after every flight. Failure to do so may result in the

battery becoming damaged. The charging process is electronically

monitored, but do not leave it unsupervised.

•Switchoffthehelicopterandtheremotecontrol.

•Carefullyplacethehelicopterwiththefuselagefacingupwardsonthe

remote control. In the process, make sure that the circuit board

contacts are guided into the slot on the remote control (4A).

•‚ThechargingprocessbeginswhenthebluechargeLEDinthe

helicopter illuminates (4B).

•ThechargingprocesshasbeencompletedwhentheUSBpluglightsup.

•Removethehelicopterfromtheremotecontrolafterthecharging

process.

After a charging time of 20-30 minutes, the helicopter can fly

for approx. 5-7 minutes.

5 START PREPARATION

The thrust controller (the left controller on the remote control) must

point down before being switched on (5A). Then briefly press the

ON/OFF button on the remote control (5B) and the Power LED blinks

red. Now set the ON/OFF switch on the underside of the helicopter to

the „ON“ position (5C).

Place the helicopter on the ground so that

its tail points toward you. Then briefly apply full throttle with the left

joystick, after which the Power LED on the remote control illuminates

permanently red. Now the helicopter is ready to start. After the flight,

first switch off the helicopter, then the remote control. Press and hold

the ON/OFF button on the remote control for approximately 3 seconds

to switch it off.

2 REMOTE CONTROL

2A Up/Down thrust control

2B ON/OFF button

2C Infrared transmitter

2D Controller for left/right

2E Left/right trim buttons

2F Charging station

2G Power LED

2H Battery compartment cover

3 INSERTING BATTERIES (REMOTE CONTROL)

3A Unscrew and remove the cover.

3B Insert 4 x 1.5 V AA batteries and pay attention to the polarity,

as shown in the battery compartment.

3C Close the battery cover and secure with the screw.

1 HELICOPTER

1A Counter-rotating rotor blades

1B Stabiliser

1C Infrared receiver

1D ON/OFF switch

1E Charge socket

damage of the battery and

neighbouring parts, as well as

physical injury!

•Neveruseachargerfor

NiCd/NiMH batteries!

•Alwaysensurethatthe

charging process takes place on

a fireproof surface in a

fire-resistant environment.

•Donotleavethebattery

unsupervised during the

charging process.

•Neverdisassembleoralter

the battery contacts. Do not

damage or puncture the battery

cells. There is a risk of explosion!

•TheLiPobatterymustbekept

out of reach of children.

•Whendisposingofbatteries,

they must be discharged or

their capacity must be fully

depleted. Cover exposed

terminals with adhesive tape in

order to prevent short-circuiting!

Maintenance and care:

•Pleaseonlyuseaclean,damp

cloth to wipe off the helicopter

•Protectthehelicopterand

batteries from direct sunlight

and/or direct heat.

•Neverallowthehelicopterto

come into contact with water.

This may result in its electronics

becoming damaged.

•Transformers,mainsadapters

or chargers which are used

together with the model must

be checked regularly for

damage to cables, plugs,

housings and other parts and

any damages must be repaired

before the devices may be

used again.

Required batteries for

the multicopter:

Power supply:

Ratedoutput:DC3.7V/0.33Wh

Batteries: 1 x 3.7 V rechargeable

LiPo battery (interchangeable)

Capacity: 90 mAh

Battery requirement for

the remote control:

Power supply:

DC 6 V

Batteries: 4 x 1.5 V “AA”

(not included)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Table of 2

Comentários a estes Manuais

Sem comentários

Revell 23955 Instruções de Utilização Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Brinquedos controlados à distância Revell 23955